Electrical Connection - ROBLIN Dune XLS Manuel D'instructions

• Push fit connection 15 onto the hood body
outlet.
• Insert the connection extension pieces laterally
14.1 in connection 15.
• Make sure that the outlet of the extension pieces
14.1 is horizontally and vertically aligned with
the chimney outlets. If this is not the case, adjust
the position by either reversing the connection
extension pieces 14.1 and then reassemble as
described previously.
• Ensure that the activated charcoal filters have
been inserted.
• Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm.
Upper exhaust flue
• Slightly widen the two sides of the upper flue
and hook them behind the brackets 7.2.1,
making sure that they are well seated.
• Secure the sides to the brackets using the 4
screws 12c (2,9 x 9,5) supplied.
Lower exhaust flue
• Slightly widen the two sides of the flue and hook
them between the upper flue and the wall,
making sure that they are well seated.
• Fix the lower part laterally to the hood body
using the 2 screws 12c (2,9 x 9,5) supplied.
GB
RECIRCULATION VERSION AIR OUTLET

ELECTRICAL CONNECTION

Flue assembly
15
7.2.1
12c
1
14.1
12c
16