Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Drilling the Support surface and Fitting the Hood
ny permanent electrical installation must comply ith the latest regulations concerning this type of instal-
lation and a quali ed electrician must carry out the or . on-compliance could cause serious accidents
or in ury and ould deem the manufacturers guarantee null and void.
ATTENTION: D o n o t f o r g e t t o u s e a d e q u a t e p l u g s t o t h e s u p p o r t b r a c k e t s . En q u i r e a f t e r t h e m a n u -
f a c t u r e r s . D o a n e m b e d d i n g i f n e c e s s a r y . Th e m a n u f a c t u r e r a c c e p t s n o r e s p o n s i b i l i t y i n c a s e o f a
f a u l t y h a n g i n g d u e t o t h e d r i l l i n g a n d t h e s e t t i n g u p o f p l u g s .
• he ood can be tted onto
the lo er surface of the all furniture.
( 50 mm min. from the surface of the coo ing
appliance to the underside of the coo er hood.)
• To carry out a cutting (embedding) on
the lo er surface of the all furniture,
as indicated.
C a u t i o n : T h e p o s i t i o n o f t h e c u t t i n g a n d t h e
squares could be modified according to the
p o s i t i o n o f t h e f r a m e t h i c k n e s s 3 0 m m .
• A plate of compensation of 50,40 or
20 mm (provided) can be xed at the bac
hood
LI . If necessary, one
precut on the plates of compensation
of 40 and 20 mm allo s to obtain 0 and 10 mm.
To unscre the
scre s located bet een the lamps.
To remove lighting brac et in order to reach
xings of the plate of compensation.
All manuals and user guides at all-guides.com
3
2
1
Publicité
Table des Matières
