Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8327827
TOOL USE AND CARE
1.
Use the correct tool for the job. Maximize tool performance and
safety by using the tool for its intended task.
2. This product was designed for a specific function.
Do Not:
a.
Modify or alter the tool; all parts and accessories are designed
with built-it safety features that may be compromised
if altered.
b.
Use the tool in a way for which it was not designed.
3. Avoid unintentional starts. Be sure the regulator is in the neutral
position when not in use.
4. Maintain the product with care (see Maintenance).
INSTALLING AIR QUICK COUPLER
Prepare a standard NPT male air quick coupler for use with your tool.
1.
Wrap the external threads of the male quick coupler with
sealant tape.
a.
Wrap the tape in a clockwise direction so it will not unravel.
b.
Do not tape all the threads. Leave several leading threads
unwrapped for easier alignment.
2. Screw the quick coupler into the tool's air inlet and tighten with a
wrench until snug.
3. Run compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
UNPACKING
1.
Carefully remove the tool from the package.
2. Retain packing material until you have carefully inspected and
satisfactorily installed or operated the tool.
3. Inspect the parts carefully to make sure the tool was not damaged
while shipping.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
1/2 in. dr Composite Air Impact Wrench
V 3.05
7
Publicité
Table des Matières
