Lubrication - PRO-POINT 8327827 Manuel D'utilisateur

V 3.05
6. Wipe the tool with a lint free cloth after each use.
7. Make sure the anvil is clear of dirt or debris. If possible, spray it with
compressed air before and after each use.
8. If an inline oil / filter system is not used, lubricate the tool daily by
holding it so that the air inlet is facing up. Squeeze the trigger and
place one or two drops of air tool oil into the air inlet. Squeezing
the trigger allows the oil to circulate in the motor.

LUBRICATION

1. It is very important that the tool be properly lubricated. Without
proper lubrication, the tool will not work properly and parts will
wear prematurely. Manually dropping a drop or two of air tool oil
once a day into the tool's male connector is better than using an
automatic in-line lubricator, which should only be required when
there are multiple users of the same tool.
2. Keep the air line lubricator filled and correctly adjusted. The in-line
lubricator should be regularly checked and filled with air tool oil.
Proper adjustment of the in-line lubricator is performed by placing
a sheet of paper next to the exhaust ports and holding the throttle
open approximately 30 seconds. The lubricator is properly set
when a light stain of oil collects on the paper. Excessive amounts of
oil should be avoided.
3. Air tool oil is the only recommended lubricant for use in all air
tools. Do not try to use other types of lubricants to oil your tools.
Using the wrong lubricant will cause premature tool failure and
/ or loss of power. Use only recommended lubricants, specially
made for pneumatic applications. Substitutes may harm the rubber
compounds in the tool's O-rings and other rubber parts.
4. Oiling your air tool regularly is important, but it is also important
not to over oil your air tool. Over oiling can cause premature tool
failure. Your tool may not be ruined, but it will begin to experience
loss of power that will continually get worse until it no longer
works. The tool then has to be taken apart and cleaned of
excess oil.
5. All air tools are packed in grease to prevent corrosion of internal
parts during shipping and storage. We recommend you clean this
out to have optimum performance from your new air tool. Add a
generous amount of air tool oil in the air inlet, and then run the tool
under no load until exhaust is clear to remove packing grease. To
maintain, add only one or two drops daily.
10
All manuals and user guides at all-guides.com
1/2 in. dr Composite Air Impact Wrench
For technical questions call 1-800-665-8685
8327827