Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8327827
6. To maintain complete control, firmly hold your tool with both
hands. Do not place hands over air vents. Do not touch the
metal parts.
7.
Never point the tool towards yourself. If it should slip, part of your
body could come in contact with moving parts.
8. Never force the tool. Excessive pressure could bend or break the
tool or accessory, resulting in damage to the tool, your work piece
or serious personal injury. If your tool runs smoothly under no load,
but does not run smoothly under load, then excessive pressure is
being used.
9. Use an appropriate dust respirator when working for an extended
period of time. This will help prevent breathing in the fine dust
created while working.
10. After changing the sockets and accessories or making adjustments,
make sure any other adjustment devices are securely tightened.
Loose adjustment devices will be violently thrown.
11. Always use the correct socket that matches the drive size.
Improper use could lead to possible injury to the operator, damage
to the tool or work piece.
12. Always check sockets and accessories for damage before each use.
Damaged sockets and accessories can break during use and cause
serious injury.
AIR TOOL PRECAUTIONS
1.
Extended exposure to air tool noise may cause hearing loss. Ear
protection gear can reduce or eliminate the noise level.
2. Inspect the tool's air line for cracks, fraying or other faults before
each use. Discontinue use if the air line is damaged or hissing is
heard from the air line or connectors, while operating the tool.
Replace the defective component/air line.
3. Do not allow people, mobile equipment or vehicles to pass over
the unprotected air line. Position the air line away from high traffic
areas, in a reinforced conduit or place planks on both sides of the
airline to create a protective trench.
4. Prevent damage to the air line by observing the following:
a.
Never carry the tool by the air line.
b.
Keep the air line behind the tool and out of the tool's
work path.
c.
Keep the air line away from heat, oil, sharp edges or
moving parts.
Visit www.princessauto.com for more information
All manuals and user guides at all-guides.com
1/2 in. dr Composite Air Impact Wrench
V 3.05
5
Publicité
Table des Matières
