Maintenance Tips - General DAF3008 Mode D'emploi

MAINTENANCE TIPS

When the icon appears in the lower left corner of the LCD, it's time to
change the anemometer's "CR2032" battery (although measurements will
remain valid for several hours after the icon first appears). To change the
battery, follow the Setup Instructions on p. 4.
Remove the battery if you do not expect to use the DAF3008 for an extended
period of time (months or years).
Replace the vane and sensor protection cap (Fig. 1, Callout A) following each
measurement session.
Do not drop or disassemble the unit or immerse it in water.
Do not operate the anemometer:
• Near a magnet
• Near equipment like arc welders and induction heaters that generate an
electromagnetic field
• In environments full of water vapor, dust or static electricity
To clean the housing or LCD, use a dry or damp cloth. Avoid using chemical
cleaners.
8
All manuals and user guides at all-guides.com