Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Align the two
outer keyhole
slots on the hood
with the mounting
screws that were
partially tightened
into the wall
framing. Ensure
that hood is
seated entirely on
mounting screws
and that hood is
level. Then tighten
screws completely.
9. Install (2) 4mm
x 38mm long
screws into the
holes inside the
hood and tighten
them securely.
10. Attach non-
ducted filters to
grease filter using
(8) filter clips.
11. Reinstall grease/
non-duct filter
assembly by
aligning rear filter
tab with slots in
the hood. Pull
down the metal
latch tab, push
filters into position and release. Make sure filters are securely engaged after
installation.
- 14 -
Publicité
Table des Matières
