Best WTT21I3 Serie Mode D'emploi page 13

INSTALL THE HOOD
(Non-Ducted Hoods Only)
NON-DUCT KIT MODEL ANKWTT320 OR ANKWTT326 CONTENTS
NOTE
Non-ducted installations
require Non-Duct Kit,
Model ANKWTT320 (for
30" wide hood) or Model
ANKWTT326 (for 36" or 42"
wide hood).
1. Center the non-duct
plenum over the hood
location and flush with
the ceiling. Secure the
non-duct plenum to the
wall using (2) 4mm x
38mm mounting screws.
Note: Drywall anchors
may be needed (not
included).
2. Tighten the screws
completely. Make
sure that the non-duct
plenum is tight against
the wall and ceiling.
3. Remove damper flaps
from damper / duct
connector and discard
flaps.
4. Remove the protective
plastic film covering the decorative flue and the hood at this time.
5. Attach the 8" round duct connector to the top of the hood using (4) 4mm x
8mm mounting screws.
6. Remove the grease filters by pulling down the metal latch tab and tilting filters
downward to remove.
7. Remove all internal foam fillers that support the blower assembly inside the
hood.
NON-DUCT PLENUM
ASSEMBLY
NON-DUCTED RECIRCULATION FILTERS
FLEXIBLE DUCT
Flush with
the ceiling
Upper flue mounting
bracket slots
- 13 -
2 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
Pan Head)
8 FILTER CLIPS
Ceiling
L C
Center of
installation