Safety Precautions - Panasonic VIERA TC-32A410C Mode D'emploi

Safety Precautions

CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
WARNING: To reduce the risk of electric shock,
do not remove cover or back. No user-serviceable
parts inside. Refer servicing to qualified service
personnel.
The lightning flash with arrowhead within a
triangle is intended to tell the user that parts
inside the product are a risk of electric shock
to persons.
The exclamation point within a triangle
is intended to tell the user that important
operating and servicing instructions are in
the papers with the appliance.
Note to CATV System Installer
This reminder is provided to direct the CATV system
installer's attention to Article 820-40 of the NEC that
provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
Secure Ventilation
Slots and openings in the cabinet and the back or
bottom are provided for ventilation, and to ensure
reliable operation of the TV and to protect it from
overheating. These openings must not be blocked or
covered. There should be at least 4 inches (10 cm) of
space around the TV. The openings should never be
blocked by placing the TV on a bed, sofa, rug or other
similar surface. This TV should not be placed in a built-in
installation such as a bookcase unless proper ventilation
is provided.
Important Safety Instructions (TV set)
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer's instructions.
4
English
All manuals and user guides at all-guides.com
8) Do not install near any heat sources such as
9) Do not defeat the safety purpose of the polarized
10) Protect the power cord from being walked on
11) Only use attachments / accessories specified by the
12) Use only with the cart, stand, tripod,
13) Unplug this apparatus during lightning storms or
14) Refer all servicing to qualified service personnel.
15) Operate only from the type of power source
16) Follow all warnings and instructions marked on the
17) Never push objects of any kind into this TV through
18) If an outside antenna is connected to the television
radiators, heat registers, stoves or other apparatus
(including amplifiers) that produce heat.
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does
not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
apparatus.
manufacturer.
bracket or table specified by the
manufacturer, or sold with the
apparatus. When a cart is used,
use caution when moving the cart /
apparatus combination to avoid
injury from tip-over.
when unused for long periods of time.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
indicated on the marking label. If you are not sure
of the type of power supplied to your home, consult
your television dealer or local power company.
TV.
cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a fire
or electric shock. Never spill liquid of any kind on
the TV.
equipment, be sure the antenna system is
grounded so as to provide some protection against
voltage surges and built up static charges. In the
U.S. Section 810-21 of the National Electrical
Code provides information with respect to proper
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of antenna discharge unit, connection to
grounding electrodes, and requirements for the
grounding electrode.