Placing A Call; Putting A Call On Hold - Cisco SPA302D Guide De Démarrage Rapide

The default PIN is blank, so do not enter a PIN. Press the left
S 7
TEP
softkey to confirm that you want to register the handset. The
"registering" message appears.
To verify that the handset registered to the base
S 8
TEP
station, confirm that the signal strength icon is solid
(not flashing) and that the handset ID, such as
Handset 1 or Handset 2, appears near the top right
corner of the display screen.
Using Your Cisco SPA302D

Placing a Call

To place a call, do one of the following tasks:
• Enter the number on the keypad and press the green Start Call button.
Depending on your phone system configuration, you may have to enter
a digit, such as 9, before entering the number to place an external call.
• To use the speakerphone, enter the number on the keypad and press
the Speakerphone button.
Answering or Ignoring a Call
To answer an incoming call, do one of the following tasks:
• Press the Start Call button.
• Press the left softkey to select Answer.
• Press the Speakerphone button to answer with the speakerphone.
To decline to answer a call, press the right softkey to select Ignore.

Putting a Call on Hold

To put a call on hold, press the left softkey to select Options.
Scroll to Hold and press the center Select button. The hold icon
and on-screen message indicates a call is on hold.
To resume the call, press the left softkey to select Options. Scroll
to Resume and press the center Select button. The active call
icon indicates the call is active again.
6 Cisco SPA302D