Charging The Handset - Cisco SPA302D Guide De Démarrage Rapide

Handset Setup and Registration

Charging the Handset

Remove the back cover of the handset.
S 1
TEP
Insert the two AAA rechargeable batteries (included) into the
S 2
TEP
handset. (See
Correct battery placement is shown on the label inside the battery
compartment. If the batteries are charged, the handset turns on
when the batteries are inserted. If the batteries are not charged,
the handset turns on when it is placed into the charging cradle.
Remove the protective film from the handset and charging cradle.
S 3
TEP
Insert the power clip into the power adapter.
S 4
TEP
Plug the power adapter into the power source.
S 5
TEP
Connect the power adapter into the charging cradle in the port
S 6
TEP
shown below.
Only use the power adapter designed for use with Cisco
C
AUTION
SPA300 Series devices.
Place the handset into the charging cradle. The light on the
S 7
TEP
charging cradle appears solid green when the handset is charging.
Charge the handset for a minimum of 10 hours before using the
handset for the first time to ensure that the handset is fully charged.
4
Battery Warning in "Before You Begin.")
Cisco SPA302D