Control Instructions For Use; Switching The Control On; Elements Setting; Using The Low Power Scale - Bertazzoni 30 Série Manuel D'utilisation Et D'entretien

CONTROL INSTRUCTIONS FOR USE

When the cooktop is connected to the electrical
voltage supply all lights and digits turn on to
indicate a proper activation. This operation will be
completed after few seconds, the control turns off
automatically. Now the cooktop is ready for
operations.

Switching the control on

Eventually hold the [LOCK] key in case the
commands are locked (see that the lock led is on
and turns off after a few seconds).
Touch the main [ON/OFF] key in order to make
each single zone available for selection.
All the displays show power level "0", if no actions
are performed the control shuts down again after
about 10 seconds.

Elements setting

Touch the proper [ON] key (ref.2) in order to
select the desired zone: the HOT SURFACE
(ref.3) indication starts flashing, waiting for a user
input.
Figure 6.
Touch the slide bar to set the power level (levels 0
to 9 are available), moving the finger along it or
directly touching the desired value.
The display (ref.4) and the "Peacock Tail" (ref.6)
show the power level, updated in real time.
After a 5 seconds time-out the value is accepted,
the HOT SURFACE led (ref.3) stops flashing and
gets steady. The "Peacock Tail" disappears after
some seconds more.
Touch [ON] key to confirm the value before the
time-out expires.
The following picture represents the Full Power
Scale whereas the control uses all the available
power range,
corresponding to level 9.
Level 4 corresponds to 15% of the available
power.
Figure 7.

Using the Low Power Scale

Once a cooking zone has been selected, touch
the [LOW TEMP] key (ref.8) in order to enable the
Low Power Scale (ref.9) then set the power level
in the usual way.
Figure 8.
10
from 0% up to the 100%