Sony SRS-WS1 Manuel D'instructions page 50

Haut-parleur sans fil portable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FCC Related Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Supplier's Declaration of Conformity
Trade Name: SONY Model: SRS-WS1
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego, CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device nay not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating with any
other antenna or transmitter except Grant condition.
FCC RF exposure information (SAR)
This device meets the government's requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The exposure standard for wireless devices employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg.
Tests for SAR are conducted using standard operating positions accepted
by the FCC with the device transmitting at its highest certified power level
in all tested frequency bands. Although the SAR is determined at the
highest certified power level, the actual SAR level of the device while operating can be
well below the maximum value. This is because the device is designed
to operate at multiple power levels so as to use only the poser required to reach
the network.
In general, the closer you are to a wireless base station antenna, the lower the
power output. While there may be differences between the SAR levels of various
devices and at various positions, they all meet the government requirement.
Pursuant to FCC regulations, you are cautioned that any changes or
modifications not expressly approved in this manual could void your authority
to operate this equipment.
For Customers in Canada
CAN ICES-3 (B)/NMB-3(B)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt
RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
PROHIBITED USAGE
・Stop using the product if you feel unwell during the use
Stop using this product immediately if you feel unwell during the use.
・Do not lay or charge the product when you are wearing it
・Wear it correctly. Make sure that it does not vibrate the surface
of your neck directly
There is a risk of resulting in an accident or causing you to feel unwell.
・Do not use the product on the plane
Radio waves may cause the computer system to malfunction potentially
resulting in an accident.
・Do not use the product inside medical institutions such as
hospitals, or near medical devices
Radio waves may cause medical devices to malfunction potentially resulting in
an accident.
・Unplug the AC adaptor when not using the product for a long
period of time
For your safety, unplug the AC adaptor from
use the product for a long period of time.
・When not in use
As this product is not disconnected from the
just turned off, unplug to disconnect this product completely.
RECYCLING RECHARGEABLE BATTERIES
Rechargeable batteries are recyclable.
You can help preserve our environment by returning your used rechargeable
batteries to the collection and recycling location nearest you.
For more information regarding recycling of rechargeable batteries, visit
https://www.sony.com/electronics/eco/environmental-management
Caution: Do not handle damaged or leaking rechargeable batteries.
PRECAUTIONS
On safety
• Important information such as the model name is inside the slit.
• When using the supplied AC adaptor, plug it into the household power
outlet (U.S.A./Canada 120V AC).
On placement
• Do not set the product in an inclined position.
• Do not leave the product in a place subject to high temperatures, such as direct sunlight,
near a heat source or under lighting equipment.
• Do not leave any objects susceptible to magnetism (cash cards, credit cards with
magnetic coding, etc.) near the product.
• Do not use or leave the product in a car.
Others
• Even if you do not intend to use the product for a long time, charge the battery to
its full capacity once every 6 months to maintain its performance.
On AC adaptor
• When unplugging the AC adaptor, do not pull the inserted USB cord. You must hold
the AC adaptor itself when unplugging it.
• Turn the power off before plugging or unplugging the product. It may cause the
product to malfunction if you plug or unplug the product when the power is on.
• The supplied AC adaptor is designed only for this product. You cannot use it for other
devices.
• Do not leave the AC adaptor in a cramped place such as a book shelf or a built-in cabinet.
• AC adaptor should be installed near an easily accessible AC power outlet.
• Model name & Serial number of AC adaptor is located on the surface of AC adaptor.
AC power outlet
if you do not
AC power
when this product is
SRS-WS1 4-739-637-13(1)

Publicité

Table des Matières
loading

Table des Matières