Push Button; Display Loops - Diehl Metering Sharky 774 Instructions De Montage

5.2 Push button

A touch button is mounted on the front plate of the meter. This push
button is used to switch to the various displays.
Action
Briefly press the key
(<3 seconds)
Hold the key
(> 3 seconds)
Do not press the key for
4 minutes
Press the key again

5.3 Display loops

The data read by the integrator can be viewed in several displays. These
displays contain the assigned system information (e.g. accumulated
energy, accumulated volume, flow, power, actual temperatures, ...) and
can be accessed by calling the displays in the pre-defined sequence / loop.
The display content of each loop is programmed at factory with standard
information.
Various display windows consist of up to seven value displays alternating
in the 2 - 4 s rhythm.
The display is updated every 2s, since an internal calculation takes place
every 2s.
Code of the loop
-30-
English
Deutsch
Function
Switch within one loop
Switch to the next display loop
Meter turns off the display automatically
(energy saving, only if no error prevails)
The meter is in the basic display
Français Español