vitapur Designer Série Guide D'utilisation Et D'entretien page 8

Cleaning the Inside of the Dispenser
To prevent mineral deposits that can affect the taste and flow of the water, and
to ensure proper product performance, your water dispenser must be cleaned
every 4 months.
1. Unplug the power cord.
2. Remove the water bottle and bottle support collar.
3. Drain the reservoir (see Draining the Reservoir on pg. 5).
4. Pour a water dispenser cleaner or a mixture of 4 cups / 1 L of vinegar with
4 cups / 1 L of hot water into the reservoir and wait 20 minutes. If using a
Vitapur cleaning solution, please follow the manufacturer's
®
instructions.
IMPORTANT: To avoid water overflow while cleaning the dispenser, always
remove the bottle support collar before pouring water or a
Vitapur cleaning solution into the reservoir (see Figure A on pg. 3).
®
5. Press both dispensing taps until water no longer comes out.
IMPORTANT: Collect the water into a container, not the drip tray.
6. Rinse with clean water and drain (see draining the reservoir).
7. Replace the bottle support collar and the water bottle (see Installing the Water Bottle on pg. 3).
IMPORTANT: Drain approximately 4 glasses of water from each tap before initial use. This does not need to be
done with replacement bottles.
Going Away on Vacation
When not using the dispenser for long periods of time or when going on vacation, unplug the dispenser and drain the
reservoir (see Draining the Reservoir on pg. 5). Follow Initial Product Cleaning Procedures upon return and startup of
the dispenser.
www.ghpgroupinc.com
8
Cleaning Kit
Available online at