HP Photosmart Wireless e-All-in-One B110 Serie Mode D'emploi page 7

Fixing connectivity issues
You may have picked the wrong network or typed in your network name (SSID)
incorrectly
Check these settings to ensure that they are correct.
You may have typed in your WEP key or your WPA encryption key incorrectly.
• If you are using encryption on your network, you'll need to enter a key. These are case-
• If the network name (SSID) or the WEP/WPA key are not found automatically during
• The Network Diagnostic Utility runs on computers with Windows XP SP3, Vista, or Windows
You may have a router problem.
Try restarting both the printer and the router by turning off the power on each. Then, turn them on
again.
Your computer may not be connected to your network.
Make sure that the computer is connect to the same network to which the HP Photosmart is
connected.
Your computer may be connected to a Virtual Private Network (VPN)
Temporarily disconnect from the VPN before proceeding with the installation. Being connected to
a VPN is like being on a different network. You will need to disconnect from the VPN to access the
printer over the home network.
Security software may be blocking communication.
Security software (firewall, anti-virus, anti-spyware) installed on your computer may be blocking
communication between the printer and the computer. An HP diagnostic utility runs automatically
during installation and can provide messages about what might be blocked by a firewall. Try
temporarily disconnecting your firewall, anti-virus, or anti-spyware applications to see if you can
finish the installation successfully. You should re-enable the security applications after installation is
complete.
Setup your firewall software to allow communication over UDP port 427 (Windows).
After software installation
If your printer has been successfully installed, but you are having trouble printing:
• Turn off the router, printer, and computer. Then, turn on router, printer, and computer -- in that
• If powering down and up doesn't solve the problem, run the Network Diagnostic Utility
• Go to:
sensitive so be sure that it has been entered correctly.
installation, and you don't already know them, you can download the Network Diagnostic
Utility, which can help you locate them.
7 OS. The computer should also be wirelessly connected to your network. To download the
Network Diagnostic Utility, go to: www.hp.com/go/wirelessprinting.
order.
(Windows):
www.hp.com/go/wirelessprinting
run it.
to download the Network Diagnostic Utility, then
7