Troubleshooting - Kärcher K 2.35 Manuel D'utilisation

TROUBLESHOOTING

Disconnect the machine from the power source before making any repairs.
ymptom
Motor will not start.
Unit does not reach high
pressure.
Output pressure varies
high and low.
All manuals and user guides at all-guides.com
Cause
On/Off switch is in the "OFF"
(O) position.
Power cord is not plugged in.
Extension cord is too long.
Extension cord is not proper gauge.
Extension cord is damaged.
Electrical outlet does not supply
adequate power.
Diameter of garden hose is too
small.
Water supply is restricted.
Not enough inlet water supply.
Water inlet filter is clogged.
High/Low pressure nozzle is in low
pressure position.
Not enough inlet water supply.
Pump is sucking air.
Water inlet filter is clogged.
Discharge nozzle is obstructed.
Calcified gun, hose or power
nozzle.
Solution
Turn switch to the "ON"
(I) position.
Plug in power cord.
Replace extension cord with
either a 25 ft. 12/2 gauge cord
or a 50 ft. 10/2 gauge cord.
Try a different outlet.
Replace with a 1/2 inch or 5/8
inch garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source full force.
Remove filter and rinse out in
warm water.
Turn High/Low pressure nozzle to
high pressure position.
Turn water on full force. Check
garden hose for kinks, leaks or
blockage.
Check that hoses and fittings are
air tight. Turn off machine and
purge pump by squeezing trigger
gun until a steady flow of water
emerges through the nozzle.
Remove filter and rinse out in
warm water.
Blow out or remove debris with a
fine needle.
Run distilled vinegar through
detergent tank.
11