SLEEP FUNCTION
The device can be set to turn off after a preset time has elapsed. The sleep setting can be adjusted
between 10 and 90 minutes in 10-minute intervals.
Setting the sleep timer
1. Switch on the device, and select the listening source you desired.
2. Press the Sleep button to call up the function.
– The word "90 MIN" and the symbol >
3. Repeatedly press the Sleep button to select the sleep time in 10-minute intervals.
The device will switch off after the preset sleep time has elapsed.
Cancelling the sleep timer
1. To cancel the sleep timer before the chosen sleep time has elapsed; press the Sleep button until
the word "00 MIN" shown on the display.
– The device remains switches on, and the symbol >
2. If you switch on the device and switch off the device before the sleep time has elapsed, press the
On/Off button.
– The symbol >
< disappears, and the device is switched off.
REMINDER FUNCTION
The device can be set to remind you by sounding the signal tone at a preset time. The reminder time
setting can be adjusted from 10 to 120 minutes in 10-minute intervals.
1. Switch the device to standby mode, press the NAP button on the remote control.
The display shows "NAP 10" and the symbol "NAP" flashes.
2. Repeatedly press the NAP button to select the reminder time in 10-minute intervals.
After the time has expired, a signal tone sounds.
3. Switch off the signal tone by pressing the On/Off button.
or
Interrupt the function early by setting the reminder time to "NAP 00" using the NAP button.
All manuals and user guides at all-guides.com
< is shown on the display.
< disappears.
17
INFORMATION
Technical data
Mains operation
Power Supply
Battery operation
(For remote control only)
Operation
Maximum Power
Consumption
Standby
FM
Frequency Coverage
MW
Loudspeaker
Circuit Features
Output power
Auxiliary input socket
Headphone socket
FM
Aerial System
AM
General
Dimension of unit
Technical and design modifications reserved.
Never open the device casing. The manufacturer will not accept any liability for damage resulting from
improper handling.
General information on laser devices
You will find a symbol similar to the one shown here on the bottom of the
device.
CLASS 1 LASER PRODUCT means that the laser is designed in such a
way as to ensure that the maximum permissible emission value cannot be
exceeded under any circumstances.
If operating devices or methods other than those specified here are em-
ployed, it may lead to dangerous exposure to emissions.
Invisible laser radiation is emitted if the CD compartment is opened and the safety locking mechanism is
shorted. Do not expose yourself to this radiation.
Environmental note
This product has been made from high-quality parts and materials which can be reused
and recycled.
Therefore, do not throw the product away with normal household waste at the end of
its life. Take it to a collection point for recycling electrical and electronic device. This is
indicated by this symbol on the product, in the operating manual and on the packaging.
Please find out about collection points operated by your local authority.
Help protect the environmental by recycling used products.
AC 230V, 50Hz~ only
2 x 1.5V (R03 / UM4 / AAA size)
35 W
2 W (with display backlighting switched off)
87.5 – 108MHz
522 – 1620 kHz
2 x Ø34 mm
Size
1 x Ø77 mm
2 x 4 ohm
Impedance
1 x 6 ohm
2 x 3 W
1 x 6 W
Ø3.5 mm
Ø3.5 mm
Wire Antenna
Loop Antenna
316L x 176H x 189D (mm)
18