Resetting The System - Pioneer XV-S100DV Mode D'emploi

Masquer les pouces

Table Des Matières

100

Table des Matières

Additional Information

Problem

Tuner

Noisy radio reception

Auto tuning does not pick up

some stations.

MP3 playback

The disc containing the MP3

tracks won't play.

The message UNPLAYABLE

MP3 FORMAT appears when

you try to start playback.

Some tracks seem to be

missing from the disc.

General

The remote control doesn't

seem to work.

No audio, or audio is dis-

torted.

Static electricity or other external influences may cause

malfunctioning of this unit. In this case, unplug the

power cord and then plug back in. This will usually reset

the unit for proper operation. If this does not correct the

problem, please consult your nearest Pioneer service

center.

All manuals and user guides at all-guides.com

Remedy

• Check that the frequency is correct.

• Check that the antennas are connected properly. For FM, make sure that the antenna

is fully extended and positioned to give the best reception.

For AM, make sure that the loop antenna is pointing in the best direction.

• If the radio signal is weak, an outdoor antenna will usually give better results than the

supplied indoor types.

• Other electrical equipment, such as TVs, fluorescent lamps and motors can cause

interference. Try switching off or moving the equipment, or moving the antenna(s).

• Auto tuning will only detect radio stations with a good signal. For more sensitive

tuning, connect an outdoor antenna.

• If the disc is a recordable CD, make sure that the disc is finalized.

• Check that the disc is ISO 9660 compatible.

• Check that the track(s) are in the MPEG1 Audio Layer 3 format.

• Check that the sampling rate of the track(s) are 44.1 or 48kHz.

• If a track name does not end in ".mp3" or ".MP3", this system will not recognize it as

an MP3 track.

• This system only recognizes the first 250 folders and tracks on a disc. If there are

more folders/tracks than this, you will not be able to play them.

• This system is not compatible with multi-session discs. If the disc is multi-session, you

will only be able to play tracks recorded onto the first session.

• Make sure that you're using the remote within its operating range and that there are

no obstacles between the remote and the sensor on the main unit.

• Check that the batteries are not exhausted.

• Check that the correct function is selected (DVD/CD, etc.), the volume turned up.

• Check that the MUTE function is not on and that the disc is not paused.

• Check that the disc is clean and undamaged (page 91)

• Check that all rear panel connections are correct.

• If you find dirty or oxidized plugs/terminals, clean them.

1 Switch the system into standby using the

2 Hold down the front panel 7 button for 7