Haier HLP21N Guide De L'utilisateur page 17

OPTION 2 - PORTABLE
NOTE: In order for this washer to meet the regulated energy standards, the faucet
supplying the water must be set to cold.
1. Remove the aerator from your faucet nozzle.
2. Examine the faucet to determine if it has internal or external faucet threads.
•
Internal threads - Keep the rubber washer
•
External threads - Remove the rubber washer
faucet connector onto the faucet.
NOTE: The faucet connector (provided) is threaded so that it will fit MOST
faucets. If the provided faucet connector does not fit your faucet, you will need
to purchase a faucet connector in the correct size.
3. Thread the silver faucet connector onto the faucet.
Internal Threads
4. Attach the quick-sink faucet adaptor to the grey end of the inlet hose making
sure the pre-installed flat washer is between the hose and the adaptor.
5. Attach the quick-sink faucet adaptor to the silver faucet connector by pulling
down on the white collar while pushing upwards on the faucet. Release the white
collar and it will lock into place.
6. Turn on the water faucet and check for leaks. If there is any leaking, check for
loose connections and tighten.
Removable Washer
Secondary Washer (Do not remove)
Washer Support (Do not remove)
Silver Faucet Connector
External Threads
Rubber Washer
Silver Faucet Connector
Quick-sink Faucet Adaptor
Water Inlet Hose
in place
before threading the
15