Haier HLP21N Guide De L'utilisateur page 16

2. Thread the white end of the inlet hose by hand onto the inlet valve on the back of
the washer until snug. Then using pliers, tighten an additional two-thirds turn.
IMPORTANT: To avoid damage to the hose coupling, do not overtighten.
NOTE: To avoid damage to the washer inlet valve, do not use plumber's tape or
sealants on the valve threads.
OPTION 1 - FIXED
NOTE: In order for this washer to meet the regulated energy standards, the faucet
supplying the water must be set to cold.
1. Thread the grey end of the inlet hose onto the water faucet by hand until snug.
Then using pliers, tighten an additional two-thirds turn.
IMPORTANT: To avoid damage to the hose coupling, do not overtighten.
NOTE: To avoid damage to the faucet do not use plumber's tape or sealants on
the valve threads.
2. Turn on the water faucet and check for leaks. If there is any leaking, check for
loose connections and tighten.
14
Cold