Location Requirements - Haier HLP21N Guide De L'utilisateur

LOCATION REQUIREMENTS

•
T he washer must be installed on a solid floor to minimize vibration during the
spin cycle. A concrete floor is best.
•
T he floor should be level with maximum slope of 1" (25 mm) under entire washer.
•
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
•
Do not install on carpeting.
•
The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of
power cord on the back of the washer.
•
Water faucet must be present within 3 ft. (0.9 m) of the connection on the
washer.
•
Only connect to cold water tap (faucet).
•
The water pressure should be between 20 and 100 psi (138 and 690 kPa).
Do not install or operate the washer where it will be exposed to
temperatures below 32°F (0°C). Water remaining in the washer will
freeze and cause damage to the washer.
WASHER DIMENSIONS
6
WARNING
29²⁹⁄₃₂ "
(76.0 cm)
17¼ "
(43.8 cm)
17¹⁹⁄₃₂ "
(44.7 cm)