Menu Level 1: Set Temperature - Waeco CoolAir CA-1000-AC Notice De Montage Et D'utilisation

_CA-1000.book Seite 41 Freitag, 28. Juli 2006 10:35 10
CoolAir

5.3.2 Menu level 1: Set temperature

The system always starts with a defined value for the room temperature.
This parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 40).
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the Mode button (see fig. 15 on page 7, 4) to change the
parameter.
➤ Use the + and - buttons (see fig. 15 on page 7, 6 and 7) to select the
temperature (in °C) with which the system starts.
✓ The digits in the display flash until the parameter you enter is
confirmed.
➤ Press the Mode button (see fig. 15 on page 7, 4) to confirm your
entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 1 and can use the + and - buttons to switch
between menu levels.
5.3.3 Menu level 2: Switching from AC to AC/DC operation
You can upgrade the roof air conditioner with the CA-DC kit so that it can
not only be used with the vehicle stationary, but also while driving. To do
this, you must reconfigure the system software. No alterations need to be
made in this menu when you operate the system without a CA-DC
upgrade kit.
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 40).
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + button (see fig. 15 on page 7, 6) once to switch to menu
level 2.
➤ Press the Mode button (see fig. 15 on page 7, 4) to change the
parameter.
✓ The digits in the display flash until the parameter you enter is
confirmed.
➤ Press the + and - buttons (see fig. 15 on page 7, 6 and 7) to select AC
mode (
➤ Press the Mode button (see fig. 15 on page 7, 4) to confirm your
entry.
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 2 and can use the + and - buttons to switch
between menu levels.
All manuals and user guides at all-guides.com
) or AC/DC mode ( ).
01 02
Installation
41