Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Volume 1
Tone 1
5
0
10
0
Input 1
Mic/ Inst.
MADE IN CHINA
FABRIQUÉ EN CHINE
MANUFACTURED FOR YORKVILLE SOUND, CANADA
Traynor TVM50 Battery Powered Combo-Amplifier
General
The Traynor TVM50 is a 50-Watt, battery-powered, combo amplifier that answers the need for a portable, all-purpose
sound system. The TVM50 can be used practically anywhere with one or two microphones or instruments. The amp
also features RCA auxiliary input jacks. These may be used to connect an audio source such as a CD player, tape
deck, MP3 player or even laptops using the appropriate audio adapters.
Control Panel
Input 1 Jack
This versatile input has been optimized to accept any
line level signal, low-impedance or high-impedance
microphones. The combi-connector accepts cables
with either XLR or ¼-inch TRS phone plugs.
Input 1 Volume (Mic/Inst.) Control
The Channel 1 volume control adjusts the level of the
audio signal connected to the Input 1 jack.
Input 2 Jack
A guitar, bass guitar, keyboard or microphone can be
connected to the TVM50 using this ¼-inch phone jack.
Always use a shielded cable. An instrument (guitar,
bass or keyboard) or a high impedance microphone
may be connected to the TVM50 using this ¼-inch
phone jack using a standard ¼-inch shielded cable.
Input 2 Hi-Z Lo-Z Select Switch
Select Lo-Z when using low impedance microphones
or Hi-Z when using high impedance microphones or
musical instruments.
Input 2 Equalization
The TVM50's 3-band EQ adjusts the Bass, Mid and
Treble for input 2.
All manuals and user guides at all-guides.com
Gain
5
5
Hi-Z
10
0
10
Input 2
Lo-Z
CAUTION: This unit contains a sealed rechargeable battery. Improper disposal of battery or replacement with
any other type may cause leakage, explosion, and/or personal injury. Not user serviceable, refer to qualified service technician.
TVM50
Bass
Mid
Treble
5
5
5
0
10
0
10
0
10
The Power LED illuminates Yellow when the unit is on and fully charged. Red illumination indicates low
battery power status. To recharge, turn Power off and connect supplied 15 VDC charger to charger jack.
The Charger LED illuminates Red while unit is charging. When charging cycle is
complete, the LED will automatically turn off. When the charger is plugged in and the
Power LED fails to illuminate, the unit must be recharged for 24-hours. If the Power
LED fails to illuminate Yellow after charging, the internal battery may be deemed dead.
Refer to Owner's Manual for more detailed instructions about replacing the internal battery.
Charger LED
DC Charger
Illuminated
When Charging
-
15 VDC
+
1500 mA
It is suggested that all tone controls be set to
the center position (12-O'clock prior to operation.
Adjustments can then be made to achieve the
desired tone. If feedback occurs while you are using a
microphone, try turning down the Treble until it stops.
Input 2 Volume
The Input 2 Volume control adjusts the level of the
signal connected to the Input 2 ¼-inch jack.
Aux. Input (Media)
The Aux. Input (Media) RCA jacks can be used to
connect a tape deck, CD player, MP3 player, drum
machine, computer or any line-level audio source.
Since the TVM50 is a mono amplifier, these jacks sum
the signals internally, mixing the incoming L and R
stereo signals into a mono signal. If the signal is mono,
(e.g. the monitor or aux. output from a mixer), connect
to either the L or R jack. Using a stereo signal?
Connect to both RCA jacks as usual, so that both
channels (L and R) are amplified.
Phones Jack
Connect standard stereo headphones to this jack using
a ¼-inch stereo plug.
Note: the internal speaker is disconnected when the
Phones jack is in use.
1
TVM50
Volume 2
5
On
0
10
Aux. Input
Insrument
Phones
(Media)
MODEL TYPE: YS1058
1v0
Power
Publicité
Table des Matières
