Safely Disposing Of Packaging Material; Mounting The Bracket - Videotec UEBP4 Manuel D'instructions

5.1 Unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
When returning a faulty product we recommend
using the original packaging for shipping.
Keep the packaging in case you need to send the
product for repairs.
5.2 Safely disposing of packaging
material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
5.3 Contents
Check the contents to make sure they correspond
with the list of materials as below:
• Fastening support
• Bolts and screws
• O-ring
• Ethernet cable
• Mobile connector for ethernet, with quick
connector
• Mobile connector for power supply and I/O, with
quick connector
• Perforation masking
• Instruction manual
2
6 Installation

6.1 Mounting the bracket

Take special care when attaching and
fastening down the apparatus. If it is to
be attached to a concrete surface you
must use dowel pins with a traction
torque rating of at least 300dN each. For a
metal surface use screws with a diameter
of at least 8mm and of an appropriate
length. The fastening system must be
capable of supporting at least 4 times the
weight of the entire equipment (product,
accessories, supports and adapters).
The support can be combined with other different
types of supports (UEAW, UEBW) or it can be directly
fastened to the chosen surface.
Fasten the support using the 3 holes (01). Use the
screws with a diameter equal to 8mm.
01
Fig. 1
For correct perforation of the fastening surface, use
the perforation masking supplied.
For installation combined with the UEBW support,
fasten the support with quick connectors (02) to the
wall support (03) using the screws and the washer
(04) supplied, paying attention to alignment of the
two supports (Fig. 2, page 3).
MNVKUEBP4_2222_EN