Before The First Use - Krups KB 50 Mode D'emploi

English
CAUTION: the safety precautions are part of the appliance. Read them carefully before using
your new appliance for the first time. Keep them in a place where you can find and refer to
them later on.
DESCRIPTION
A Motor unit
B " SMOOTHIES" button
C " ICE CRUSH" button
D Control knob
E Blender jug assembly
e1 Blade unit
e2 Gasket seal
Graduated blender jug
e3
e4 Lid
e5 Measuring cap

BEFORE THE FIRST USE

n Clean all the parts (E) with warm water and washing up liquid except for the motor unit (A) which must
never be immersed in water or placed under running water (see § Cleaning).
CAUTION: The blades are extremely sharp; handle them with caution when using or cleaning
the appliance.
n Make sure all the packaging has been removed before operating the appliance
n Important note: Turn the control knob (D) to
n The appliance will start only if the blender jug is positioned correctly on the motor unit.
n Do not operate the appliance if the lid is not in place.
ASSEMBLING AND FITTING THE JUG
n Fit the gasket seal (e2) on the blade unit (e1) (Fig.1).
n Place the assembly (e1+e2) on the base of the jug (e3). Lock it by rotating the blade unit through a
quarter turn in an anticlockwise direction (Fig.2).
n Introduce the ingredients to the assembled jug.
n Place the lid (e4) on the jug. Place the measuring cup (e5) in its slot on the lid.
n Place the blender jug assembly (E) on the motor unit (A). The blender jug can be placed in two positions:
jug handle to the right or the left of the motor unit (Fig. 3).
USING YOUR APPLIANCE FOR THE FIRST TIME
n Once the blender jug is positioned correctly on the motor unit, plug in the appliance and turn it on using
the desired function.
n Speed selection: Turn the control knob (D) to choose the desired speed; the speed increases gradually
between mini " " and max " ". You can change this speed as required during preparation.
n "Pulse" function: Turn the control knob (D) to the "Pulse" position. Using a succession of pulses gives
finer control over the degree of blending for precise preparations. In this position, the appliance starts
directly on maximum speed. It stops as soon as you release the knob.
n Function " SMOOTHIES"
This function is used to prepare smooth milkshakes and fruit cocktails. The speed is pre-programmed for
best results. To use this function, turn the control knob to
to start the appliance. To stop it, press the "SMOOTHIES" button (B) again.
8
F " " Stand By Mode
0
G " " Min Speed
H " " Max Speed
before placing the blender jug on the motor unit (A).
0
0 , and press the "SMOOTHIES" button (B)