Panasonic Omnivision PV-C1322-K Manuel D'utilisation page 9

lay)
Manual Clock Set
If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
1
Press ACTION on the Remote to
display SET CLOCK Menu screen.
2 Press
and press
manner, select and set the date,
year, time, and DST. (Daylight
Saving Time)
3
Press ACTION twice to start
CLOCK and exit.
POWER
ACTION
All manuals and user guides at all-guides.com
SET CLOCK
:
1 / / 1 / /
DST : ON
SELE CT MONTH
SELECT :
SET :
END : ACT I ON
to select the month
to set. In the same
SET CLOCK
:
2 / 6/ 2002 WED 12 00PM
DST : ON
SET COMPLETED
SET :
START : ACT I ON
POWER EJECT NITE SLEEP
DISPLAY
1 2 3
TAPE POSITION
4 5 6
COUNTER
8
7 9
R-TUNE ADD/DLT
0
100
MUTE SEARCH
C H
SELECT/SET
:CH UP
VOL VOL
SELECT
:CH DOWN
ACTION PROG
C H
:VOL UP
STOP REW/ PLAY FF/
:VOL DOWN
REC
PAUSE/SLOW CM/ZERO
FM/TV SPEED
Reset all unit Memory Functions
When moving unit to a new location, or if a
mistake was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
POWER POWER VOL VOL CH CH STOP/EJECT REW/ STOP/EJECT REW/ PLAY/REPEAT FF/ PLAY/REPEAT FF/ REC TIMER/FM REC TIMER/FM
REC ON TIMER PROG TIMER REC ON TIMER
ACTION ACTION
VIDEO IN VIDEO IN AUDIO IN AUDIO IN
1
Turn the unit
Power on.
2
Press and hold both PLAY and
FF on the unit for more than 5
seconds.
• The power will shut off.
• Please ignore "NO CASSETTE" warning.
3
Do "Initial Setup" on page 8.
Note to CABLE System Installer
This reminder is provided to call the
CABLE (Cable TV) System Installers
attention to Article 820-40 of the NEC
that provides guidelines for proper
grounding and, in particular, specifies
that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
PROG TIMER
9 9