Panasonic Omnivision PV-C1322-K Manuel D'utilisation page 21

All manuals and user guides at all-guides.com
Cancel a Timer Recording:
(Recording is in progress)
Hold down STOP for a few seconds
to cancel the Timer Recording.
• Any future daily or weekly recordings
will be performed as programmed.
POWER EJECT NITE SLEEP
DISPLAY
1 2 3
TAPE POSITION
4 5 6
COUNTER
8
7 9
R-TUNE ADD/DLT
ADD/DLT
0
100
MUTE SEARCH
C H SELECT/SET
:CH UP
VOL VOL
SELECT
:CH DOWN
ACTION PROG
C H
:VOL UP
STOP REW/ PLAY FF/
:VOL DOWN
REC
PAUSE/SLOW CM/ZERO
FM/TV SPEED
PROG
STOP
Review, Replace or Clear Program
Contents :
(Recording is not in progress)
1
Repeat steps 1 and 2 on page 20.
2
Press
P DT START STOP CH SPD
1 day day 9 9 : 00 00p 12 12 : 00 00a 08 08 SP SP
the desired program.
2 8 10 : 00a 12 : 00p 125 SP
3 10 8 : 00p 9 : 00p 10 SP
4 SU 9 : 00p 10 : 00p L LP
CANCEL : ADD / DLT
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
3
To Replace program...
1) Press
DATE START STOP CH
8 SAT SAT 9:00 00P P 12 12: 00 00A 08 08
2) Press
TODAY ABC
CATEGORY : MOV I E SP
----------------------------------------------
SE SELE CT START START DAT ATE
SELECT :
SET :
END : PROG / ACT I ON
3) Press PROG (or
To Clear program...
Press ADD/DLT.
P DT START STOP CH SPD
1 -- -- -- -- : -- -- -- -- : -- -- -- -- -- --
2 8 10 : 00p 12 : 00a 125 SP
3 10 8 : 00p 9 : 00p 10 SP
4 SU 9 : 00p 10 : 00p L LP
SELECT 1 - 8 :
ENTER :
END : PROG / ACT I ON
4
Press PROG twice (or ACTION)
to exit this mode.
Notes
• 2 minutes before Timer recording is performed,
"PLEASE PREPARE FOR TIMER REC" appears and/
or the PROG TIMER Indicator flashes. Be sure a
cassette with record tab is loaded and the unit is in
Stop mode.
• If the start times of two programs overlap, the lower
numbered program will have priority.
• If the start time for a Timer Recording comes up during
a normal recording or One Touch Recording (page 12),
the Timer Recording will not be performed.
• If there is a power interruption of more than one minute,
the recording may not be performed or continued.
• If "INCOMPLETE" appears after all items have been
set, check all entries and make necessary corrections.
to select
to display.
to select
and press or
to set new program
contents.
ACTION).
21