Padding Instructions; Removing The Ironing Cloth; Fitting The Ironing Cloth (Only For Steel-Wool Roller Covering) - Miele PRI 210 Mode D'emploi

Padding instructions

Before the ironing cloth can be removed for the purpose of cleaning or replacing the
roller, the rotary iron must be switched off and the heater plate allowed to cool down.

Removing the ironing cloth

Before the ironing cloth can be removed from rollers with steel-wool padding, the laun-
dry pickers on the roller need to be fully retracted one after the other.
Switch on the rotary iron by pressing the  button.

Pull the finger guard up slightly.

Press and hold the  button for longer than 3 seconds.

The heater plate disengages and is locked into this position.
Repeatedly press the  button to reverse the roller incrementally (jog mode).

Take the end of the ironing cloth, and put it on the laundry infeed table.

With the roller in reverse, completely remove the ironing cloth.

After that, press and hold the  button for longer than 3 seconds to deactivate the main-

tenance position.
Wire wool residues may fall onto the laundry infeed table while the ironing cloth is being re-
moved or fitted. These residues must be removed.

Fitting the ironing cloth (only for steel-wool roller covering)

Switch on the rotary iron by pressing the  button.

Pull the finger guard up slightly.

Select the lowest temperature () and the lowest roller speed ().

Lay the ironing cloth on the laundry infeed table parallel to the roller and feed it into the

rotary iron.
The padding needs to be changed if there is a visible gap on the lower edge of the
heater plate and roller (laundry outfeed).
The stainless wool padding on the roller may only be replaced by Miele Technical Ser-
vice!
The diameter of a new or re-upholstered roller must not be less than the dimensions in-
dicated below (including the ironing cloth).
PRI 210/214
8 1/4"–8 7/16" (210–215 mm)
Within this range the roller should be wound cylindrically over its entire length.
During the replacement of the roller padding, Miele Technical Service should check
whether the carbon brushes of the drive motor need to be replaced as well.
en - Cleaning and care
PRI 217
9 13/16"–10 1/16" (250–255 mm)
35