Auxiliary Handle; Dust/Chip Extraction; Starting Operation - Bosch GBH 5-40 DCE Professional Notice Originale

All manuals and user guides at all-guides.com
OBJ_BUCH-512-003.book Page 9 Friday, August 1, 2008 12:16 PM
Assembly
Before any work on the power tool itself,
pull the mains plug.

Auxiliary Handle

Operate your power tool only with the auxil-
iary handle 9.
The auxiliary handle 9 can be set to any position
for a secure and low-fatigue working positure.
Turn the bottom part of the auxiliary handle 9 in
counterclockwise direction and swivel the auxil-
iary handle 9 to the desired position. Then re-
tighten the bottom part of the auxiliary handle 9
by turning in clockwise direction.
Changing the Tool
With the SDS-max tool holder, simpler and easier
tool changing is possible without additional aids.
The dust protection cap 1 largely prevents the
entry of drilling dust into the tool holder during
operation. When inserting the tool, take care that
the dust protection cap 1 is not damaged.
A damaged dust protection cap should be
changed immediately. We recommend hav-
ing this carried out by an after-sales service.
Inserting (see figure A)
Clean and lightly grease the shank end of the
tool.
The red symbols (open lock and bars) on the
locking sleeve 2 indicate that the tool holder is
open.
Insert the tool into the tool holder with a turning
motion until it is automatically locked. The lock-
ing sleeve automatically snaps toward the front
and the red ring is no longer visible. This indi-
cates that the tool holder is locked.
Removing (see figure B)
Pull the locking sleeve 2 back until it engages.
The red symbols on the locking sleeve can now
be seen again. The locking sleeve remains in this
position and the tool can be removed without
having to hold the locking sleeve.
Bosch Power Tools

Dust/Chip Extraction

Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials contain-
ing asbestos may only be worked by
specialists.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the type plate of the
power tool.
Setting the Operating Mode
The operating mode of the power tool is selected
with the mode selector switch 3.
Note: Change the operating mode only when the
machine is switched off! Otherwise, the machine
can be damaged.
Turn the mode selector switch 3 to the requested
position.
Position for hammer drilling
When the drilling tool does not im-
mediately rotate upon switching on,
allow the machine to run slowly until
the drilling tool rotates.
1 619 929 792 | (1.8.08)
English | 9