Cleaning The Hot Water Shower; Cleaning The Accessories; Cleaning The Appliance - SilverCrest SEM 1100 B3 Mode D'emploi

Cleaning the hot water shower

Clean the hot water shower
1) After you have prepared the espresso/cappuccino and removed the sieve
holder
tened cloth to remove all powder residues.
2) Replace the sieve holder
3) Place an empty cup under the sieve holder
button
rinsing out the remaining powder residue.
4) After about 20 seconds, press the "Espresso" button
switch the appliance off with the On/Off switch
5) Remove the sieve holder

Cleaning the accessories

1) Clean the sieve holder
measuring spoon
NOTE
► If you put detergent into the water, it may effect the taste of the espresso.
If the stains can only be removed with detergent, always rinse the items
afterwards with lots of clean water.
2) Dry all parts well.
3) The drip tray
remove the red float from the drip tray
–
–
–
–

Cleaning the appliance

Clean the appliance with a moist cloth. If necessary, use a little detergent on the cloth.
Ensure that the appliance is completely dry before the next use.
SEM 1100 B3
All manuals and user guides at all-guides.com
after each use:
, wipe the entire surface of the hot water shower
without the espresso filters
down until it clicks in. Water flows out of the hot water shower
again.
, the two espresso sieves
and the drip grille
is suitable for cleaning in the dishwasher. However, always
To do this, remove the stoppers attached to the two retaining bars to the
side of the float.
Pull the float from the retaining bars.
Clean the float and stoppers.
After cleaning the drip tray
retaining bars and replace the stoppers.
and press the "Espresso"
.
, water tank
in warm water.
before cleaning:
, push the cleaned float back onto the
with a mois-
.
again and
, the
│
GB 61 ■