Handling; General; Base Station; Combination Sensor - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004

14. Handling

Observe all the safety precautions in these operating instructions!
a) General
The product may not be opened or taken apart (except for the work described in these operating instructions,
e.g. change of battery or cleaning the rain gauge).
There are no parts to be maintained by the user in the inside of the product.
The product will be damaged even if dropped from a low height.
b) Base station
Avoid the following adverse ambient conditions during operation or transport:
- moisture or excessive humidity
- extreme cold or heat direct sunlight
- dust or flammable gases, vapours or
- heavy vibration
- strong magnetic fields, such as, for example, in the vicinity of machines or speakers
Never use the product immediately if it has been taken from a cold area to a warm area. The condensation
developing could in certain cases destroy the device.
Wait until the base station has reached room temperature. This can take some hours!
A place for set-up has to be selected so that the base station stands securely and cannot fall down. There is
danger of injury due to its extreme heaviness.
Valuable or easily scratched furniture surfaces should be protected from damage by suitable mats before set-
ting up the base station.
c) Combination sensor
Although the combination sensor is protected against rain from above, this is not the case, however, from the
side or from below. Therefore, avoid any direct spraying, for example, through a garden hose or another
watering system.
Select the place of set-up so that children cannot tip the combination sensor over; do not place the combi-
nation sensor in the proximity of vehicles, glass doors, windows or similar!
7:19 Uhr Seite 57
57