Setting Time Zone - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004 7:19 Uhr Seite 45
Set the latitude using the keys "+" and "-".
Example: 52.5°, input: 525
Press the "NEXT" key. After that, you can enter the longitude. The
display shows this as "LO" ("Longitude").
Set the longitude using the keys "+" and "-".
Example: 13.4°, input: 0134
Press the key "NEXT" and now set the time zone. The display shows
"ti".
Setting the time zone
The time zone is required for the calculation of the sunrise and sun-
set times.
Enter the difference to GMT (Greenwich Mean Time).
The following values apply for Germany:
• Daylight saving + 2
• Winter time
Enter the current value for your time zone using the keys "+" and "-".
All settings have been made at this time for correct operation of the
weather station. The extended settings are not required for normal
operation.
Now press "EXIT" to leave the configuration mode and return to nor-
mal mode. Now the base station is back in normal mode.
Press the key "NEXT" to make extended settings and go to the bal-
ancing of the rain sensor.
Entering the alignment value
The rain gauge has been set to a high degree of accuracy ex works
so that you normally do not need to align it.
Simply press "NEXT" to take over the factory settings.
Otherwise the alignment value will have to be determined first of
all in normal mode (see chapter 13 d) on page 54).
Enter the previously determined alignment value using the keys "+"
and "-".
Press "NEXT" to set the unit for measuring rain.
+ 1
45