Configuration And Operation; Basic Settings, Configuration - ELV Electronik WS300 Notice D'emploi

BA 65 01 55 04.05.2004
9. Configuration and Operation
After installation of the radio sensors and the subsequent commissioning of the base station (this order must
be observed!), the data transmitted by the radio sensors should appear on the LC display of the base station.
a) Basic Settings, configuration
The following settings are still required for operation:
• Year, month, day, hour, minute
• Latitude/longitude of your position
• Time zone
You will then see the display of the moon phase and the sunset/sunrise as well as the date and the
time.
Additional settings:
• Rain sensor alignment is possible on request (however, this was already carried out by the manufacturer
so that it normally does not have to be repeated!)
• Unit of rain quantity
• Assignment of progress display (air pressure, interior or exterior temperature)
• Wind strength unit
The keys have the following functions in configuration mode:
Imprint
IN
SENSOR
MIN/MAX
RAIN
OUT
You will also find the key allocation on the back of the weather station.
Please observe:
The values are adjusted more quickly if you press the keys "+" or "-" longer when making individual set-
tings.
After each setting, you can leave the configuration mode by pressing "EXIT" or move on to the next set-
ting using the key "NEXT".
Configuration takes place in the sequence:
Year ➡ Month ➡ Day ➡ Minute ➡ Hours ➡ Latitude ➡
Longitude ➡ Time zone (ti) ➡ Rain sensor alignment ➡
Rain unit quantity ➡ Assignment of progress display ➡ Wind unit
After that, the setting order commences from the beginning again.
7:19 Uhr Seite 43
Function
EXIT
+
-
NEXT
Description
(unused)
leaving configuration mode
increase value
decrease value
to next setting
43