Saw Blades - Berner BACSS-18V Notice D'utilisation/Indications De Sécurité

All manuals and user guides at all-guides.com
E N G L I S H
WARNING: NEVER use a light socket.
NEVER connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an Extension Cable
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable
for the power input of your charger (see technical data).
The minimum conductor size is 1 mm
length is 30 m.
When using a cable reel, always unwind the cable
completely.
Assembly and Adjustment
WARNING: Prior to assembly and
adjustment, always remove the battery pack.
Always switch off the tool before inserting or
removing the battery pack.
WARNING: Use only Berner battery packs
and chargers.
Inserting and Removing the Battery Pack
from the Tool
1. Insert the battery pack (e) into the grip until it clicks
in place.
2. To remove the battery pack, press the two battery
release buttons (f) simultaneously and pull the
pack out of the grip.
ASSEMBLY
Replacing the Saw Blade (fi g. 3, 4)
1. Move the blade clamp lever (c) up to release the
blade clamping mechanism.
2. Insert the saw blade into the holder (j) until it
engages. The blade can be installed with the teeth
pointing down, up, left or right, as shown in fi gure
4.
3. Move the blade clamp lever (c) down to lock the
blade clamping mechanism.
4. To remove the saw blade, proceed in reverse
order.

SAW BLADES

A wide variety of dedicated saw blades is available as
an option.
.
Setting the Adjustable Saw Shoe (fi g. 5)
The saw shoe can be adjusted to limit the depth of cut
2 ; the maximum
and prolong the life of your saw blade.
1.
2.
3.
Instructions for Use
Prior to operation, make sure your battery pack is (fully)
charged.
OPERATION
24
material recommended saw blade
ferrous metal
non ferrous metal
wood
plastic
masonry
CAUTION: To reduce the risk of damage to
the workpiece, always select your saw blade
with great care.
Push and hold the shoe release button (k).
Slide the saw shoe (d) into one of the three
settings.
Release the shoe release button.
WARNING:
• Always observe the safety instructions
and applicable regulations.
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the tool
and do not exert side pressure on the
saw blade. If possible, work with the saw
shoe pressed against the workpiece.
This prevents damage to the blade and
stops the tool from jerking and vibrating.
• Avoid overloading.
• Let the blade run freely for a few seconds
before starting the cut.
WARNING: ALWAYS wear a dust mask.
Exposure to dust particles can cause
breathing diffi culty and possible injury.
WARNING: Turn unit off and disconnect
battery pack before installing and removing
accessories, before adjusting or when making
repairs. Lock the trigger switch when the tool
is not in use and when storing the tool.
fi ne-toothed
coarse-toothed
coarse-toothed
fi ne-toothed
carbide-tipped