Bestop Trektop Instructions D'installation page 18

Install Belt Retainers
Section 10
Attach the Belt Retainer Right (Part # 597.80)
to the vehicle body using two (2) M8 x 24 mm
Screws that were removed when the Hard Top
was removed and one (1) M6 x 15mm screw
(Part #533.61). Tighten the fasteners that mount
the Belt Retainers and Corner Retainers.
Repeat this step on the left side of the vehicle.
Tip
Remember to snap the rear trim covers
back into place before closing the tailgate.
P18 - 56872 Rev. J 1121
Tools
T30
Torx Driver
Installation Instructions - Trektop for Bronco 2 Door
Parts
Belt Retainer Right Belt Retainer Left
Part #597.80 Part #597.81
Qty. 1 Qty. 1
SCREW, M6 X 1.0 X 15mm
Part #533.61
Qty. 2
T-30 Torx
Page 18
© 2021 Bestop, Inc.