AquaScape ULTRAKLEAR 1000 Mode D'emploi page 6

• The 90º elbow fittings and Locking Rotational Ball fittings
allow 360º directional movement to accommodate the
plumbing configuration desired or the Multi-Hose Adapters
can be mounted directly onto the UltraKlear
shown below.
Multi-Hose Adapters mounted
directly to UltraKlear
®
• Fittings should be hand-
tightened only and
installed with the flat
rubber gaskets to achieve
leak-free seals.
NOTE: Do not use tools to attach the fittings.
• Select the Multi-Hose Adapter based on the diameter of
the tubing you are using. It is recommended to use as
large of a diameter of tubing as possible (up to 1 ½ inch
diameter) in order to achieve maximum water flows.
• If using a diameter of pipe larger than the smallest section
of the Multi-Hose Adapter, trim off the smaller sections to
avoid any flow restriction.
6
fixture as
®
UltraKlear ® with Rotational Ball
Fittings and Multi-Hose Adapters
Rotational Ball Fittings
Hosetail ready for ¾" tubing
Hosetail ready for 1¼" tubing
cut here
• We recommend using a
hose clamp (not included)
to secure tubing onto the
fitting.
Installation of stainless
steel hose clamp
• After connecting the
plumbing, plug the pump
and the UltraKlear into an
®
outlet that is protected by
a ground fault interrupter
(GFI). Once the pump
is running and water is
circulating through the
UltraKlear fixture, check
®
for any fitting leaks where
the external connections
are made. Since the filter is located outside the pond, even
a small leak must be corrected. Check the UV indicator
to confirm that the UV light is "On" inside the UltraKlear
fixture.
Hosetail ready for 1" tubing
cut here
Hosetail ready for 1½" tubing
cut here
stainless steel
hose clamp
Kink-Free
Tubing
®