AquaScape ULTRAKLEAR 1000 Mode D'emploi page 5

Narrow contact chamber increases
effectiveness of UV light
Internal sleeve increases contact
time, thus increasing efficiency
Additional side water flow output
allows for easier installation
High-output (HO) T5 bulb
maximizes effectiveness
On/off indicator light provides
quick verification
Mounting brackets make it simple to
attach the unit to a vertical surface
High-quality quartz sleeve
maximizes bulb output
Mechanical safety switch
automatically turns off bulb when
the ballast/bulb is removed
Electronic ballast ensures optimum
wattage and bulb output
• An optional 2-Way Flow
Control Valve (#88005) can
be used to make sure the
water flow does not exceed
the UltraKlear Maximum Flow
®
rate. Please refer to the UltraKlear
Specification Chart included in
this manual for maximum flow rate
recommendations.
• AquaForce Solids-Handling
®
Pond Pumps are ideal for use
with the UltraKlear –
®
The AquaForce
®
pre-filter cage allows
for the pump to be
submerged directly
in the pond and
improves UV efficiency
by pre-filtering
the larger debris
before reaching the
UltraKlear . Other in-
®
pond pump makes and models can also be used.
• The UltraKlear is designed to be located outside the
®
pond. We recommend placing it in a location that is easy
to hide and access for maintenance. The UltraKlear
can be attached to a board and set on level ground
or mounted using the four screw holes in the support
saddles as shown here.
1
2
5
3
8
4
9
5
6
7
treated
water
8
9
by-pass
water
UltraKlear Optional By-pass Plumbing
®
®
2-Way Flow Control Valve
AquaForce Pond Pump
®
®
1
2
7
4
UltraKlear ®
UV Clarifier
• The UltraKlear includes three plumbing ports:
®
– In–Pipe from pump (can use either end port as pond
water "In").
– Out–Pipe back to pond (use opposite end port for
discharge back to pond).
– Optional Inlet/Outlet to assist with installation and
pipe routing.
Pond Water IN
3
6
2-Way Flow Control Valve
(Item #88005)
from
pump
Optional Inlet/Outlet
Treated Water OUT
5