Valor H3 Serie Manuel D'installation page 4

5. Apply the self-adhesive wiring diagram label
provided to the fan mounting plate between its
fixing studs.
6. Position the fan control module to the front of the
fireplace, left of the receiver. Thread the power cord
around the back of the firebox post as indicated.
Front of
appliance
fan control
module wire
View looking left from inside firebox
removed)
7. Use the self-adhesive wire clamp provided to secure
the cable between the fan and the control module
to the base of the fireplace.
8. Reinstall the burner module plate inside the firebox
without fixing it in place yet.
4
power cord around back
of firebox post
fan control
module
fan mounting
plate
(burner module plate
9. Connect the fan to the receiver.
a) Detach the receiver from the Velcro and plug
in the fan control module wire in the 6-pin
connection of the receiver as indicated below.
Ensure to check the orientation of the connector.
on top
at bottom
b) Reattach the receiver to the Velcro.
10. Plug the fan's power cord into the 3-prong
receptacle in the junction box cover.
Test the fan
The fan is normally operated by the remote control sys-
tem when the fi replace is functioning. To test the opera-
tion of the fan after the connections have been made, it
is not necessary to have the fi replace operating.