Valor H3 Serie Manuel D'installation page 3

b) Do not tighten the wire clamp just yet to allow
for wire adjustment.
Approved
Wire Clamp
c) Place the junction box cover in the front left
corner of the appliance case.
d) Connect the corresponding wires and cap them
with wire nuts.
e) Tuck the wires inside the junction box and hold
it against the appliance case while pushing any
excess wire out through the wire clamp.
f) Tighten the wire clamp outside of the appliance
case.
g) Slide the tab at the far end of the box into
the slot of the appliance case located right
behind the cable clamp. Ensure the wires are
not pinched between the junction box and the
appliance case.
h) Fix the junction box to the appliance (1 screws).
4. Install the fan into the appliance.
a) Slide the fan inside the appliance case and push
it as far back as possible so that the threaded
studs at the bottom of the appliance fit tight
inside the slots in the fan mounting plate.
b) Fix the plate with two nuts provided.
3