Valor Horizon Square Trim Kit 623STV Manuel D'installation

INSTALLATION MANUAL
Square Trim Kit 623STV
Approved for use with Valor models 534 with 645CFV
The 623STV square trim is intended to be used on Valor
heaters models 534 fitted with the 645 Clearview Front.
Installation of the 623 does not affect clearances,
framing dimensions, or other specifications listed in the
heater installation manuals.
44-3/8" [1126 mm]
base line of installed heater
Cleat
base line of
installed heater
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
Designed and Manufactured by / for Miles Industries Ltd.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valorfireplaces.com
4002242-04
© Copyright Miles Industries Ltd., 2020.
Horizon
Trim
Cleat
Rear view
Note: Backing or wall anchors may be required behind
the wall finish at fixing points to secure the trim to the
wall.
534 Heater
Overview
Installation
1. Install the heater as per installation instructions
supplied with the heater. Allow for the height of the
finished hearth.
2. Install the front following the instructions packed
with the kit.
3. Mark out the position of the mounting cleat and fix
the cleat to the wall.
4. Carefully center and locate the Square trim to the
cleat and heater, ensure the magnets mounted at
bottom of each leg make contact with the heater
front.
645 Clearview Front
623 Square Trim