Table des Matières
Publicité
INSTALLATION
Dismantling for installation
• The dryer is supplied with a pressure-mounted
cover, and is not screwed down.
• The 4 attachment screws are provided
in the plastic bag with the plugs and lag bolts.
• Remove the cover vertically from the machine
supporting base, taking care to avoid:
- Damaging the internal components.
- Damaging the cover. We recommend resting
it on a flat surface with the visible part upwards,
or on top of a cloth.
Mounting
• Mount the machine along the rear channels.
• Insert the electric ducting through the hole
next to the terminal strip.
• Use the drill template provided to fix the
dryer to the wall.
• Drill 4 holes with a diameter of 8 mm(5/16"),
and take care to clean all traces of dust from the holes.
• Screw down the base firmly to the wall using a flat
ended screwdriver of 6 -7mm (1/4").
• Connect the electric ducting to the terminal strip.
Screw down the 3 locking screws firmly.
Machine must be handled only by an autorized technician.
WARNING: When dismantle the cover, electrical live and basic insulated parts are accesible.
Means for disconnection of the mains should be predicted, with a contact separation at least 3 mm (0.12") in all
poles. The mentioned means of disconnection must be incorporated in the fixing wiring.
During the installation process, the protection areas should be considered according to norm VDE 0100.
The hand dryer must only be installed on a closed surface (wall, partition or similar).
Publicité
Table des Matières
