Pool Maintenance - Bestway 53052 Mode D'emploi

WARNING
Never leave your child unattended – drowning hazard.
• Only for domestic use.
• Only for outdoor use.
• Children can drown in very small amounts of water. Empty the pool when not
in use.
• Do not install the paddling pool over concrete, asphalt or any other hard
surface.
• Place the product on a level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, overhanging branches,
laundry lines or electrical wires.
• Recommend back towards the sun when playing.
• Modification by the consumer of the original paddling pool (for example the
addition of accessories) shall be carried out according to the instructions of
the manufacturer.
• Keep assembly and installation instruction for future reference.
• Make sure the pool and slide are always connected while in use; do not
exceed the maximum weight: 45kg / 99lbs. One person on the slide at a
time. For 53097, do not exceed the maximum weight: 144kg / 317lbs, and
the maximum users on the slide is two persons at a time.
• Adult assembly required.
• Children must remove shoes and glasses, as well as any sharp or hard
objects from their pockets, as they may puncture the slide surface.
• Always keep the slide entrance free from obstruction.
• Do not allow food, drink or gum inside unit.
• Do not allow users to do somersaults or rough play.
• Do not allow users to climb or hang on containing walls.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set up on
uneven ground it can cause collapse of the pool and flooding, causing
serious personal injury and/or damage to personal property. Setting up on
uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud, sand,
soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones and
twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Assembly
1. Open the water valve to fill water in the water chamber.
(Only for product with water chamber)
2. Open the safety valves and inflate the parts one by one. Be sure to close
the valves after inflation. Air pump is not included.
NOTE: Do not over inflate. Do not use either an air compressor or
compressed air.
NOTE: For inflatable floor, the air valve is on the bottom side of the product.
3. Tie the slide to the pool with the provided ropes to the relevant grommets.
4. Connect your garden hose to the Hose Adapter.
5. Slowly fill the pool to a proper water level, if there is a fill line, reach but do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION: Do not leave pool unattended while filling with water.
Proper Water Level
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Empty the pool
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Deflate all the air chambers, at the same time push down the wall of the
pool to release the water. Make sure release all the water in 20 minutes.
NOTE: Drain by adult only!

Pool Maintenance

Warning: If you do not adhere to the maintenance guidelines covered herein,
your health might be at risk, especially that of your children.
• Change the water of pools frequently (particularly in hot weather) or when
noticeably contaminated, unclean water is harmful to the user's health.
• Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufacturer's instructions.
• Proper maintenance can maximize the life of your pool.
• See packaging for water capacity.
Cleaning and Storage
1. After use, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the product.
2. Air dry the pool, once pool is completely dry, fold pool carefully and put
back to its original packing. If pool is not completely dry, mould may result
and will damage the pool.
3. Store in a cool, dry place and out of children's reach.
4. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Repair
If a chamber is damaged, use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation.
3