Installing Your Television Set; Remote Control; The Keys On The Tv Set - Philips 21PT4355/00 Mode D'emploi

Installing your television set

The keys on the TV set

2
æ Positioning the television set
Place your TV on a solid, stable surface, leaving a space of at least 5 cm
around the appliance.
To avoid accidents, do not put anything on the set such as a cloth or
cover, a container full of liquid (vase) or a heat source (lamp).The set
must not be exposed to water.
 Connections
• Insert the aerial plug into the
Smaller sets are equipped with an internal aerial. Under certain conditions,
reception can be poor.You can improve it by repositioning the aerial. If the
reception remains unsatisfactory, an external aerial should be used.
• Insert the mains plug into a wall socket (220-240 V / 50 Hz).
ê

Remote control

Insert the two R6-type batteries (supplied) making sure that they are the
right way round.
The batteries supplied with this appliance do not contain mercury or nickel
cadmium. Please do not discard your used batteries if you have access to a
recycling facility (if in doubt, consult your dealer).When the batteries are
replaced, use the same type.
® Switching on
To switch on the set, press the on/off key.
A red indicator comes on and the screen lights up.
Go straight to the chapter Quick installation
If the television remains in standby mode, press P
control.
The indicator flashes when you use the remote control.
The television set has 4 keys which are located on the front or the top
of the set depending on the model.
The - + (-a+) keys are used to adjust the sound level.
VOLUME
The - + (- P +) keys are used to select the required
PROGRAM
programmes.
To access the menus, hold down the
simultaneously.Then use the
and the - + keys to make the adjustment.
VOLUME
To exit from the menu, hold down the
for a few seconds.
Note: when the LOCK function is activated, these keys are unavailable (see
page 6).
M
socket at the rear of the set.
on the following page.
VOLUME - and
- + keys to select an adjustment
PROGRAM
- and
VOLUME
on the remote
VOLUME + keys
+ keys
VOLUME