Oki LD610 Guide D'installation page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CuTTeR insTallaTion (ConTinued)
5. Connect the Cutter kit's cable to the oPTion connector on
the main PCB (connector is keyed).
Route the Cutter kit's cable through the groove (circled) of
the printer as shown.
6. Assemble the Bottom housing cover back to the printer and
secure with the three screws removed earlier.
CAUTION:
Ensure that no cables are pinched between parts when
you are assembling the cover.
To route the media when the cutter is installed
Loading of the media for cutter unit is similar to the usual procedure as explained in the loading labels
section of the of the ld610 user's Technical Reference.
Cutter kit's
cable
MAIN PCB
OPTION
connector
5

Publicité

Table des Matières
loading

Table des Matières