Cutter Installation - Oki LD610 Guide D'installation

CuTTeR insTallaTion

To install the optional Cutter
1. First, follow the instructions in the Removal of the Bottom
housing Cover section.
2. Turn over the printer in upright position. Pull the cover open/
close latches on both sides of the printer toward you to
unlock the Top cover, and then open the Top cover. Remove
the lower front cover by pulling the bottom slightly away
from the printer and lifting it upward.
3. Insert the latches of the Cutter Kit onto the holes located
below the two sides of platen roller of the printer and push
the Cutter Kit down to lock into place.
Close the top cover and turn the printer over again, with
the main PCB is facing upward.
note: Be sure to keep the cable positioned in the small
notch on the bottom edge of the Cutter Kit during
installation.
4. From the base of the Cutter kit, secure the cutter unit to the
printer with the supplied screw (circled) as shown.
Hole and latch
Cutter kit
4