Oki LD610 Guide D'installation page 10

disPenseR insTallaTion (ConTinued)
stop position adjustment
Normally, the label is dispensed to the point where 2 or 3mm (0.08" or 0.1") of the label remain on the liner
(backing paper).
If the label is not dispensed at the regular position, you can change the offset setting with the SBPL commands.
Please refer to the offset Position adjustment section for the detailed procedures. After adjusting the stop
position, dispense two or three labels to fix the stop position.
notes:
• T here may be cases when the dispenser does not function properly due to the thickness of the labels used.
• T he Dispenser unit is effective for label pitch 22 to 100 mm (0.86" to 3.93"). However, the label size limitation
may vary with application conditions.
• L abels over 100mm (3.9") may curl at dispenser due to the nature of the material. There is no remedy for this.
10