SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Use only machine tools, accessories and consumables, which are recommended by the manufacturer. Make sure
choosing the correct size and the correct type. Use only accessories, which are in proper condition.
CAUTION – Injury due to carelessness!
If the machine is fixed to suspension equipment make sure that it is secure. Never hang the machine
onto the supply line.
Separate the machine form any external energy source before changing the machine tool or an
·
accessory.
• Avoid direct contact with the machine tool during and after use as it can be hot or sharp.
• Wear protective gloves when changing a tool or an accessory!
Notice: Defective/ inappropriate gloves can lead to injury. Only wear proper hand protection, adapted to the work
place requirements.
WARNING – Explosion hazard!
When operating the machine in areas exposed to explosion hazards, use only accessories,
respectively devices, which are ATEX approved and specified.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
ATTENTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
• Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
• Never carry the machine at the supply line.
Wear worker's protective shoes!
Basic Safety Instructions:
WARNING – Maintenance and repair work on pneumatic equipment.
Compressed air can cause severe injury. Observe legal regulations. Take precautions for persons and
environment.
Additionally, observe the following:
• Secure machine against unintentional starting and let the machine cool down to the ambient
temperature
• Use suitable transport equipment, hoists or lifting accessories for moving heavy assembly groups
or parts. Protection against tipping, tumbling or falling down when assembling/ disassembling the
machine/parts.
CAUTION – Skin exposure to hazardous dusts may cause severe dermatitis. Dust present at the work
place could be disturbed during the maintenance procedure and inhaled. Clean machine and work
place before maintenance work.
32
SERVICE AND MAINTENANCE