Dimplex CDFI-TMHEAT Manuel Du Propriétaire page 7

Heater Installation
2. Allow at least 2 ft. (61 cm) of service cable for connecting
the power supply wire.
CAUTION: Keep min 6" clearance to the adjacent walls and min
18" clearance to the floor.
!
NOTE: Use minimum 14 AWG supply cable with two insulated
copper conductors (white and black) and one bare ground wire.
!
NOTE: The heater only exhausts from one direction. Note this
direction, see figure 7.
Figure 1
8"
(201mm)
0.4"
(10mm)
Pilot light
15"
(380mm)
12.6"
(321mm)
0.4"
(10mm)
3.4"
(86mm)
(4.5mm)
5"
(128mm)
7.6"
(192mm)
1.3"
(34mm)
0.18"
7