Dimplex CDFI-TMHEAT Manuel Du Propriétaire page 10

Heater Installation
Figure 4
Plugs into Opti-myst cassette
CDFI1000-PRO or
CDFI500-PRO, refer to
the cassette user's guide.
CAUTION: Use two
conductor, non-metallic sheath
cable with ground wire (3 wires
total) for the incoming power
supply. Use appropriate wire to
meet local and national electrical
codes for rated power.
1. On the back of the unit, remove
the cable clamp by removing
the screw at the top (Figure 4).
10
Cable
Plate
2. Install a 3/8" (10 mm) or 1/2 in.
(13 mm) cable connector, not
included, suitable for mounting
in a 7/8" (22 mm) hole, to the
cable plate and feed the supply
cable through the connector
and secure.
3. Remove the 3 wires from within
the unit.
4. Connect the black wire (live)
from the unit to the black wire
from power supply.
Heater control
wire. Used when
controlled by the
Opti-myst cassette
CDFI1000-PRO or
CDFI500-PRO.
www.dimplex.com